News details

The first is whether the material cylinder is in the center of the material cylinder support. If there is any change in the material cylinder, please install it from the beginning; The second is whether the O-ring of the charging cylinder piston is damaged. If it is damaged, please replace it. The third is that the cylinder piston and piston rod can be fastened. If they are loose, they should be locked.

Due to the variety of products produced by beverage filling machinery, if there is a fault in the production, it will bring an inestimable impact on the production. Therefore, enterprises should know more about the possible situation of machinery and how to deal with it. It can ensure that the filling machine is more efficient, high-quality and low-cost. The mechanical engineer of the filling machine summarizes common faults for your reference:

Inaccurate filling volume of the filling machine or no discharge

If the opening is delayed, the thin cylinder throttle valve shall be adjusted; The elastic force of the spiral spring is tightened up and down in the quick installation three-way control valve. If the elastic force is too large, the check valve will not open; If the filling speed is too fast, adjust the filling speed throttle valve to reduce the filling speed; Whether the speed throttle valve and the filling interval throttle valve are closed, and the throttle valve cannot be closed; Is there any foreign matter in the quick installation three-way control valve? If yes, please sort it out. Is there any air in the leather tube of the quick installation three-way control valve and the filling head? If there is air, try to reduce or remove the air as much as possible.

Check whether all sealing rings are damaged, and replace them with new ones if damaged; Check whether the filling nozzle valve core is jammed or delayed to open. If it is jammed, install the valve core from the beginning. Whether all clamps and leather pipe buckles are sealed properly, if any, please correct them; The magnetic switch is not loose, please lock it after each adjustment.

When the piston of the charging cylinder of the filling machine does not come back from the top; push it to the position of the magnetic switch, press the emergency stop switch, and adjust the active magnetic switch from the beginning.